B3487 BMW Fault Code

Description:

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

B3487 Code Symptoms :

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. B3487 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing B3487

B3487 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix B3487 code ?

• EVAP system hose leaking
• Damaged camshaft position (CMP) sensor
• Faulty ignition coil (s)
• Fuel filler cap remains open or fails to close

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.